HIGHLIGHTS
-
Redundant power supply
-
Load protection
-
Versatile to use
Multi Switch ATS
Current Range:
16 - 30 A
1:1
Multi Switch ATS为安装提供持续高效的电力保障。与单一的UPS或配有旁路的UPS相比，Multi Switch ATS的工作原理更可靠。
Multi Switch ATS能直接为8台10 A IEC设备，或一台16 A IEC设备提供配电，输入电源是任何两路电源（两路市电输入或两路UPS电源）。它能与任何两路电源连接，同时还能进行合并监测。
如果其一负载设备发生故障（例如短路），Multi Switch ATS断开负载连接的插座，以防止其它设备的中断。
Technical specifications of the model
Operating principle
Multi Switch ATS provides direct distribution of eight 10 A IEC outputs or one 16 A IEC output in the 16 A model, four 10 A IEC outputs one 16 A IEC output or a terminal board in the 30 A model in a system with two input power lines (two mains inputs, or two UPS). Multi Switch ATS is able to connect to either of the two input power lines, whilst simultaneously monitoring the power uptake.
protection against load faults
If one of the loads fails (e.g. short circuit), the Multi Switch ATS disconnects the group of sockets where the load is connected, thus preventing other loads from being switched off (i.e. in the event of poor discrimination of the protection devices).
Protection against power supply faults
If one of the two power sources falls outside tolerance levels, Multi Switch ATS will transfer the load to the second power source (switching is instantaneous if the two sources are in phase).
Features
- Full protection for loads against mains and load failures;
- Redundant power supply;
- Versatile to use: Multi Switch ATS can be powered with 2 different power supplies (including 2 UPS of different sizes/types);
- 19” cabinet installation;
- Display panel;
- Can be connected to PowerNetGuard supervision software;
- No signal connection between the Multi Switch ATS and the power sources or loads is necessary;
- Compatible with PowerShield3 software Slot for communications boards: the optional network card allows for remote in network connectivity, and management through HTTP, SNMP, and SSH protocol.
